Display/Action Keys - Simplex 4100 Operator's Manual

Page 22
To select an extended controlling action, the user must first select a point, press the
<FUNC> key, then press the <ENTER> key. One of the extended actions (see list
above) will then appear on the top line of the alphanumeric display as shown below:
MONITOR POINT 1, ZONE 1
FIRE MONITOR ZONE 1
AFTER <FUNC> KEY PRESS
F1= Clear Verification Tally
FIRE MONITOR ZONE UNVERIFIED=6
The user will then press the <FUNC> key to view the status of the selected point.
The tone-alert will beep and a different status is shown on the alphanumeric display
each time the <FUNC> key is pressed. In some cases, the user can then take action
to change point data.
controlling actions.
The extended controlling action shown above is for monitor zones.
5.6

DISPLAY/ACTION KEYS

The "DISPLAY/ACTION" keypad provides eleven keys which allow users with
appropriate access level, the ability to perform controlling functions on the system
zones, MAPNET devices, signals, and auxiliary control relays.
associated with Display while five keys are Action keys.
Action key presses require a confirmation <ENTER> key to be pressed before
performing the action on the point identifier displayed. These "DISPLAY/ACTION"
keys are concealed by the access door.
Document No.: 4100-M001
SIMPLEX 4100 FIRE INDICATOR PANEL
This technique may be used for each of the extended
Figure 10
Display / Action Keys
28 March 2006
OPERATOR MANUAL
AZF1
NORMAL
Six keys are
Issue 1.2