Alarm Conditions; How To Operate The Panel During An Alarm Condition - Simplex 4100 Operator's Manual

Page 6

3 ALARM CONDITIONS

When an alarm condition is detected, it is indicated at the main 4100 FIP by the
following:
- Red "ALARM" LED is flashing.
- Tone-alert is pulsing.
- LEDs on the local annunciator may illuminate.
- Alphanumeric display will show an alarm condition.
ALARMS = 1
The display has one red LED which is used to indicate an alarm condition. When an
alarm occurs, the red LED flashes, the tone-alert pulses, and an alarm message is
displayed on the alphanumeric display.
tone-alert is silenced upon activation of the <ALARM ACK> key. When the alarm
condition clears, the red LED will turn off and the alarm will be removed from the
alarm list. Once alarm conditions have been cleared, Alarm events can be reviewed
by examining the historical alarm log.
3.1

HOW TO OPERATE THE PANEL DURING AN ALARM CONDITION

(Red Alarm Light Flashing And Tone Alert Pulsing)
Operator Interface Panel Showing Alarm Condition
Document No.: 4100-M001
SIMPLEX 4100 FIRE INDICATOR PANEL
***ALARM*** Press ACK to review.
ISOLATED = 0
Figure 2
28 March 2006
OPERATOR MANUAL
FAULT = 0
The red LED will glow steady and the
Issue 1.2