Fasel Elektronik FCU2000-IR series Operating Manual page 28

„Basic settings" menu
1.
2.







Fig. 13: "Light settings" view (example)
3.
4.








Fig. 14: "Light settings – change mode" view (example)
5.
6.
7.
8.
9.
10. Press the
11. Option "light ON after heat-up phase" is enabled. Cursor flashes on the selected
28
Press (basic settings)
Press the key until you see the following view:
Press the key.
Following view is displayed:
Select one of the following lines with the
– Light ON at start
– Light ON if bath ready
– Falling delay time x min
Note!
Only the option "light ON at start" or "light ON if bath ready" can be selected.
Press the key. Selected line is enabled.
Option "light ON upon starting" is enabled. Cursor flashes on the selected line.
Press the key. Check mark is set (option selected).
Press the key: Check mark is deleted (option not selected).
Press the key. The selection is saved.
Exit the menu using the
key. The selected line is enabled.
line.
Press the key. Check mark is set (option selected).
Press the key: Check mark is deleted (option not selected).
Operating manual Series FCU2000/3000/4000-IR
key. The lamp next to the key must light up.




or key:



key or select the next line with the


(→ point 7)
(→ point 11)
(→ point 15)
or key.
B_FCUxxxx-IR / Version V 1.07