Table of Contents
Advertisement
12. Press the
13. Exit the menu using the
14. Press the
15. Adjust the time for turn off delay. Digit flashes.
16. Press the
17. Exit the menu using the
18. Option "light OFF at drying" is enabled. Cursor flashes on the selected line.
19. Press the
20. Exit the menu using the
7.2
„Basic settings" for Options
7.2.1
Colour light automatic
In this menu you can adjust the program sequence, if you selected the option „Auto" in
the menu „colour light mode". → See manual for program settings.
1.
7.2.2
RGB-LED settings (only for FCU4xxx and menu "Pro")
In this menu you can program the fading time (the time for a smooth colour transition
from one colour to another) for RGB-LEDs.
1.
2.
B_FCUxxxx-IR / Version V 1.07
key. The selection is saved.
key. The selected line is enabled.
Press the
key: Reduce value.
Press the
key: Increase value.
Press the
key: Select left digit.
Press the
key: Select right digit.
key. Selected value is accepted.
Press the
key. Check mark is set (option selected).
Press the
key: Check mark is deleted (option not selected).
key. The selected line is enabled.
NOTE!
This menu appears only, if the corresponding options board is installed
in the control device.
Press key
(basic settings). The lamp next to the key must light
HINWEIS!
The "RGB-LED settings" menu is only available for control devices
which are connected to a RGB-LED control from the company
Licht2000.
Press key
(basic settings). The lamp next to the key must light.
- Press the key until you see the following view:
Operating manual Series FCU2000/3000/4000-IR
key or select the next line with the
key or select the next line with the
key.
„Basic settings" menu
or
key.
or
key.
29
Advertisement
Table of Contents
