Table of Contents
Advertisement
"General settings" menu
6.3
Adjust the set point temperature, heating time, remaining heating time,
timer
The following example describes how to adjust the set point temperature.
The heating time, the remaining heating time and the timer are adjusted similarly.
Note the following points:
Heating time
The heating time is the operating time for
the selected mode..
The heating time can be adjusted if the
lamp next to the mode key flashes.
Table 6: Heating time / remaining heating time
6.3.1
Set temperature
6.3.1.1 Set temperature of IR-heater
1.
2.
fig. 2: View "Infrared" (example)
18
If you want to adjust the set point temperature, set point humidity, heating time, re-
maining heating time or the timer, the corresponding symbol must light up at the
right of the display. That is, the symbol "Temperature" should light up if you want to
adjust the temperature.
The heating time and the remaining heating time use the same symbol. The value
which you adjust depends on the status of the lamp next to the mode key.
Timer can be released or blocked. The models FCU2x00 and FCU3x00 have no
timer.
Press
-key until the symbol
The following view is shown:
Operating manual Series FCU2000/3000/4000-IR
Remaining heating time
The remaining heating time is the re-
maining time when the mode is turned
on. The remaining heating time is re-
duced automatically.
The remaining heating time can be ad-
justed if the lamp next to the mode key
lights up.
The modified remaining heating time
does not change the programmed heat-
ing time.
(IR-heater) lights.
B_FCUxxxx-IR / Version V 1.07
Advertisement
Table of Contents
