Using Your Mask - ResMed Mirage Micro User Manual

• Follow all precautions when using supplemental oxygen.
• Oxygen flow must be turned off when the CPAP or bilevel device
is not operating, so that unused oxygen does not accumulate
within the device enclosure and create a risk of fire.
•
This mask contains small parts that could cause choking. Your
clinician should assess the suitability of the mask.
•
Remove all packaging before using the mask.

Using your mask

When using your mask with ResMed CPAP or bilevel devices that have mask
setting options, refer to the Technical Specifications section in this user guide
for mask selection options.
For a full list of compatible devices for this mask, see the Mask/Device
Compatibility List on www.resmed.com on the Products page under Service
& Support. If you do not have internet access, please contact your ResMed
representative.
Notes:
• SmartStop may not operate effectively when using this mask with some
CPAP or bilevel device
• If you experience nasal dryness or irritation, using a humidifier is
recommended.
Fitting
The Fitting illustrations section in this user guide shows the sequence for
obtaining the best fit and comfort when using your mask.
1. Turn the dial, so that the forehead support is fully extended.
2. Hold the mask over your nose and pull the headgear over your head.
3. Bringing the lower straps below your ears, connect the headgear clip
to the the mask frame.
4. Unfasten the Velcro
are comfortable and firm, and reattach the Velcro.
5. Repeat step 4 with the lower headgear straps.
6. Connect the main air tubing to the swivel. Then connect the free end
of the air tubing to your device and turn on.
7 . Lie down in your sleeping position. Adjust the dial until the mask
is evenly positioned on your face. It should be comfortable, with a
satisfactory seal. Adjust the headgear straps if necessary.
8. Shows how the fitted mask is positioned.
s that have this feature.
, pull the upper headgear straps evenly until they
®
2