ResMed Mirage Micro User Manual page 10

Reassembly
Refer also to the reassembly illustrations in this user guide.
1. Insert the ports cap.
2. Insert the cushion into the mask frame. Ensure that the arrows at
base of the cushion and mask frame are aligned.
3. Push the forehead pads firmly into the forehead support.
4. Insert the forehead support (a) into the mask frame and screw (b)
the dial clockwise onto the pole. Turn the dial until it clicks (c). Ensure
the dial sits flush against the frame.
5. Insert the swivel into the end of the elbow.
6. Insert the assembled elbow into the mask frame.
7 . Reattach the top headgear straps by threading them through the
loops.
Cleaning your mask in the home
Your mask and headgear should be gently handwashed only.
Daily/After each use:
• Disassemble the mask components according to the disassembly
instructions.
• Thoroughly clean the separated mask components (excluding headgear),
by gently rubbing in warm (approximately 86°F/30°C) water using mild
soap.
• To optimize the mask seal, facial oils should be removed from the cushion
after use.
• Use a soft bristle brush to clean the vent.
• Inspect each component and if required, repeat washing until visually
clean.
• Rinse all components well with drinking quality water and allow to air dry
out of direct sunlight.
• When all components are dry, reassemble according to the reassembly
instructions.
Weekly:
• Handwash the headgear. It may be washed without being disassembled.
4