Tailoring Treatment Setup Options; Using Mask-Fit - ResMed Stellar 100 User Manual

Tailoring treatment setup options

Setting Ramp
Programs

Using mask-fit

You can use mask-fit to help you fit your mask properly. This feature delivers constant
treatment pressure for a three-minute period, prior to starting treatment, during which you
can check and adjust your mask-fit to minimise leaks. The mask-fit pressure is the set
CPAP or EPAP pressure or 10 cm H
1
Put the mask on according to the mask user guide.
2
Hold down
3
If necessary adjust the mask, mask cushion and headgear until you have a good mask fit.
After three minutes treatment will begin. Mask-fit can be stopped at any time by pressing
Notes:
• Press
• The mask-fitting feature is disabled when the mask type Trach is selected.
14
Ramp time
Program
for at least three seconds until pressure delivery starts.
for at least three seconds during mask-fit to start the treatment immediately.
Ramp time is a feature that can be enabled
by your clinician by setting a maximum ramp
time. Designed to make the beginning of
treatment more comfortable, ramp time is
the period during which the pressure
increases from a low start pressure to the
treatment pressure. See "Setup menu:
Options" on page 16.
If the Clinician has selected both, ie, dual,
you can choose the program to use on the
Treatment screen. If only a single program is
selected, the option does not display.
O, whichever is greater.
2
.