Chapter 4 Procedures And Settings Before System Operation - Mitsubishi MELSEC Q series User Manual

CHAPTER 4
The following flowchart shows the steps to be performed before data logging operation.
CPU module
Insert an SD memory card into the slot of the CPU module.
Power on the CPU module
Set the CPU module switch to RUN.
For installation of the CPU module, power supply module, and SD memory card, and the installation environment, refer to
the following.
User's Manual (Hardware Design, Maintenance and Inspection) for the CPU module used
44
PROCEDURES AND SETTINGS
BEFORE SYSTEM OPERATION
Start
Connect the personal computer to the CPU module.
End
Personal computer
Install the configuration tool.
Start the configuration tool.
Configure data logging settings.
Select a communication route in the "Transfer
Setup" dialog box of the configuration tool.
Write the settings to the CPU module.
Start data logging.
Page 47, Section 5.2
Page 47, Section 5.3
Page 110, Section 8.4
Page 136, Section 8.6
Page 145, Section 8.8
Page 149, Section 8.10