GPS Tracker TK510 User Manual page 21

TK510 GPS Vehicle Tracker
AD1 Blue
AD2 Blue
AD3 Blue
AD4 Blue
 Power/GND
Connect Power (+Red) & GND (-Black) wires to the battery of vehicle.
 Input1, Input2 & Input3 (Negative Triggering)
Input2 is connected to negative (ground), once it is disconnected from
negative signal(Ground), it will trigger the power cut alarm. it is useful to protect
the cargo by binding the wire around it.
 Input4 & Input5 (Positive Triggering)
Input 4 is connected to ACC ON position to detect the engine ON/OFF
status;
Input 5 can also be used to detect any positive (+12V) triggering signal.
when it has continuous 5 seconds of +12VDC signal, it will trigger the alarm.
The input 5 can also be used for arm/disarm automatically if it is connect to
Engine ON/OFF status & switch the function by sending SMS command:
10 bits Resolution Analog Inputs. 0-5V DC detection ,
connect with temperature/fuel sensor etc.
10 bits Resolution Analog Inputs. 0-5V DC detection ,
connect with temperature/fuel sensor etc.
For optional use
For optional use
Input 1
White
GND -
Input 3
White
GND -
Input 4
White
Page 20
User Manual
SOS Button
Door Switch