Page 1
GSM/GPRS/GPS TRACKER MANUAL Preface Thank you for purchasing the tracker. This manual shows how to operate the device smoothly and correctly. Make sure to read this manual carefully before using this product. Please note that specification and information are subject to changes without prior notice in this manual. Any change will be integrated in the latest release.
Contents 1. Summary ..........................3 2. Applications ..........................3 3. Hardware Description ......................3 4. Specs............................4 5. Usage ............................4 SIM card installation ......................5 Battery and Charger ......................5 Startup ..........................5 Initialization ........................6 Change the password ....................... 6 Add and Delete Authorized phone number ..............
Page 3
5.20.3 Deep Sleep by Shock/vibration ................15 5.20.4 wake according to schedule..................15 5.20.5 No sleep mode ......................15 5.21 Check the Vehicle State ....................15 5.22 Check IMEI ........................15 5.23 Terminal (local) Time Setting..................16 5.24 Reset Hardware ......................16 5.25 Configure parameters by USB ..................
1. Summary Working Based on existing GSM/GPRS network and GPS satellites, this product can locate and monitor any remote targets by SMS or internet. 2. Applications Vehicle rental / Fleet management etc Powerful magnet + water-proof bag, adsorbing in the hidden place of car for tracking secretly.
SIM card slot Interior Install the battery like this 4. Specs Content Specifications Dim. 64mm x 46mm x 17mm(1.8” *2.5” *0.65” ) Weight Network GSM/GPRS Band 850/900/1800/1900Mhz GPS sensitivity -159dBm GPS accuracy Cold status 45s Time To First Fix Warm status 35s Hot status 1s 12—24V input Car charger...
SIM card installation Make sure that there is no call transfer and call display is on, and PIN code off. The SMS message must in Text format, can’t be identified for PDU format. 5.1.1. Open the rear cover, and pick out the battery. 5.1.2.
When this unit receives GPS signals normally, you can use it and do any setting as the instructions of this manual. Initialization Send SMS command “begin+password” to the unit, it will reply “begin ok” and initialize all the settings. (Default password: 123456) For example, send SMS “...
Single Locating If there aren’t any authorized number set-up, it will reply all calls with a location report; if 5.7.1 there are authorized numbers set-up, then it will not respond when an unauthorized number calls 5.7.2 If you call it from authorized phone number, it will hang up and report a real -time location as below: 5.7.3 When lost fix to satellites, it will track by LBS / CELL-ID.
5.8.3 Smart track upon time and distance interval 5.8.3.1 Please set "track with unlimited times upon time interval" before this function, and send "distance+password+space+distance", tracker will reply "Distance ok", and then tracker will locate upon both the pre-set time and distance. e.g.
locating, Location reports will include the GPS coordinates of the last known positions as well as a LAC code, Entering the LAC code to the “Manual Track” menu of web tracking platform www.gpstrackerxy.com will enable you to see the tracker’s current location. You can also send command “address+password”...
means device does not work under GPRS mode. 5.15.2 Specified date Load: Send SMS: “load+ password+ space+ year month date” to tracker device, it will reply: “load ok” and load the tracking data to the web platform upon the valid time you choose.
5.19 Alarms 5.19.1 Low battery alarm 5.19.1.1 Send SMS “lowbattery+password+space+on”, it will send SMS “low battery+latitude/longitude” to authorized numbers 2 times in total in 15 minutes interval when voltage of battery is going to be about 3.55V. 5.19.1.2 This function activates by default, send SMS “lowbattery+password+space+off” to deactivate.
Example: Send "area123456 22.353648,113.543678 school,800M". Note: 5 areas at most and the distance between two points can't be less than the total distance in the 2 commands, and different areas can't cover each other. 5.19.5.2 Delete areas Send SMS command:"noarea+password+space+area name", tracker will reply:"noarea ok". 5.19.5.3 Rename and set distance Send SMS command "rename+password+space+old name;new name,distanceM"...
Activate shock alarm: Send SMS “shock+password” to tracker, it will reply 5.19.8.1 “shock is activated!”, that means shock alarm function activates successfully. Tracker will send “sensor alarm+latitude/longtitude” to authorized phone numbers when it detect shock. Cancel: send SMS “noshock+password” to tracker to cancel this function. 5.19.8.2 Sensitivity configuration ( First level is the default level) 5.19.8.3...
No vibration and other triggered alarm, tracker will sleep, GPS No vibration and no other hardware module and GSM module both shut triggered alarm, GPRS offline and off, tracker works in minimum switch to “Deep sleep by shock”, and Deep sleep power consumption, Always online...
5.20.3 Deep Sleep by Shock/vibration Send "sleep+password+space+deepshock", tracker will reply " sleep deepshock ok!" it will enter deep sleep if no vibration, GPS & GSM module shut off, and LED will be off too. Only vibration can awake the tracker, it will send wake up message automatically after wake up.
5.23 Terminal (local) Time Setting Send SMS “time+space+zone+password+space+local time zone”, it will reply “ time ok!” after execute the command. For example, Send SMS “time zone123456 8” (time zone of China). If the local time zone is negative as “-8”, then it should set as SMS: “time zone123456 -8”.
compulsorily necessary, therefore, the entry can be skipped. For those countries requiring user name and password, please configure as following: Send SMS “up+password+space+user+space+password”, If executed, tracker will reply “user, password ok!”, for example: send SMS “up123456 jonnes 666666” Note: 123456 is password of tracker, jonnes is the user name for GPRS login, 666666 is the password for GPRS login.
5.28.2 Cancel monitor center number Send “nocenternum+password” to tracker, it will reply “no center num ok”. 5.29 Instructions f or web platform and mobile APP Users need to register an account on www.gpstrackerxy.com before use web or APP platform, account name and password is the same on web/APP platform. 5.29.1 Register an account 1.choose the right...
Page 20
4. Input the newly registered user ID and password, click "login" 5.29.3 a terminal 5. add terminal 6. add terminal 7. enter IMEI 8. Device name 9.choose location icon 10. Save 11. The newly registered device is offline in grey color 5.29.4 Configure your tracker to web platform to track it online Step 1:set APN,refer to 5.26.1...
Step 3:set IP and port, please use the corresponding IP and port of the server you choose, refer to 5.26.3 Step 4:switch to GPRS mode,refer to 5.26.4 12. After receiving GPRS OK, wait about one minute, tracker will be online in green color, you can operate the tracker.
Don’t put the unit in overheated or overcooled places. Handle carefully. Don’t vibrate or shake it violently. Please use a dry cloth to clear and don’t use chemicals and cleaners. Please don’t paint the device, this may lead to internal circuit failure. Please don’t disassemble the device.