Table of Contents
Advertisement
High Definition Satellite Receiver
10.6. OSD Setting
When you input to "OSD Setting" menu, you will see a
screen like below:
OSD Timeout: When you switch channels in full
1 .
screen, there will show up some information about
current channel on the lower of the screen . And
regarding to the duration of these information
show up on the screen, you can press
set the time . The range of the duration is "1 second
~ 10 seconds" .
2 .
OSD Transparency: You can press
select the values . There are 5 levels of transparency,
10%, 20%, 30%, and 40% and "NO" (means no
transparency function) .
3 .
Press Exit key to draw back from the "OSD Setting"
menu .
10.7. Favorite
When you input to "Favorite" menu, you will see a screen
like below:
When press OK key, you can rename the favourite group's
name . It will display the dialogue like below:
1 .
Press Yellow key to enable/disable CAPS LOCK .
2 .
Press Red key to delete the char on the cursor .
Press Blue key to save .
3 .
10.8. Other
/
key to
/
key to
In "LNB Power", there are two options, "On" and
1 .
"Off", for your selection . If the setting is "On", the
receiver will supply power to satellite antenna . If the
setting is "Off", the receiver won't supply power to
satellite antenna .
2 .
In "Beeper", there are two options, "On" and "Off",
for your selection . If the setting is "On", when enter
"Antenna Setup" menu, the receiver will make a
continuous sound when signal is locked, and make
a intermittent sound when signal is unlocked . If the
setting is "Off", enter "Antenna Setup" menu, the
receiver won't make any sound .
In "Auto standby", you can set standby mode, if
3 .
user does not operate over 3 hours .
Press Exit to draw back from "Other" menu .
4 .
22
Advertisement
Table of Contents
