Mapping A Service Template To A Radio - H3C MSR Series Configuration Manual

To configure 802.11n:
Step
1. Enter system view.
2. Enter AP template view.
3. Enter radio view.
4. Specify the bandwidth mode
for the radio.
5. Enable access permission
only for 802.11n clients .
6. Enable the short GI function.
7. Enable the A-MSDU
function.
8. Enable the A-MPDU
function.
For information about Modulation and Coding Scheme (MCS) index and mandatory and supported
802.11n rates, see

Mapping a service template to a radio

Step
1. Enter system view.
2. Enter radio interface view.
3. Configure a radio type.
4. Map a service template to
the radio.
Command
system-view
wlan ap ap-name [ model
model-name [ id ap-id ] ]
radio radio-number type
{ dot11an | dot11gn }
channel band-width { 20 | 40 }
client dot11n-only
short-gi enable
a-msdu enable
a-mpdu enable
"Configuring WLAN RRM."
Command
system-view
interface wlan-radio
interface-number
radio-type { dot11b | dot11g |
dot11gn }
service-template
service-template-number
interface wlan-bss
interface-number
17
Remarks
N/A
Specify the model name only
when you create an AP template.
N/A
Optional.
By default, the 802.11gn radio
operates in 20 MHz mode.
Optional.
By default, an 802.11gn radio
permits both 802.11b/g and
802.11gn clients to access.
Optional.
By default, the short GI function is
enabled.
Optional.
By default, the A-MSDU function
is enabled.
The device receives but does not
send A-MSDUs.
Optional.
By default, the A-MPDU function
is enabled.
Remarks
N/A
N/A
Optional.
Optional.
You can map multiple service
templates to the radio.
If you use the WLAN BSS
interface together with the IMC
binding service, make sure the
interface number of the WLAN
BSS interface is no more than 31.
For more information about IMC,
see H3C Intelligent Management
Center Getting Started Guide.