Configuring Radio Parameters - H3C MSR Series Configuration Manual

Step
4. Enable the fat AP to respond
to probe requests with null
SSID.

Configuring radio parameters

Configuring radio parameters
Step
1. Enter system view.
2. Enter radio interface view.
3. Configure a radio type.
4. Specify a working channel for the
radio.
5. Specify the maximum radio
power.
6. Specify the type of preamble.
7. Configure the antenna type.
8. Configure the maximum distance
that the radio can cover.
9. Set the interval for sending
beacon frames.
10. Set the DTIM counter.
11. Specify the maximum length of
packets that can be transmitted
without fragmentation.
Command
broadcast-probe reply
Command
system-view
interface wlan-radio
interface-number
radio-type { dot11b | dot11g
| dot11gn }
channel { channel-number |
auto }
max-power radio-power
preamble { long | short }
antenna type type
distance distance
beacon-interval interval
dtim counter
fragment-threshold size
15
Remarks
Optional.
The default setting is enabled.
Remarks
N/A
N/A
Optional.
Optional.
By default, auto mode is enabled.
The working channel of a radio
varies with country codes and
radio types. The channel list
depends on your device model.
Optional.
By default, the maximum radio
power varies with country codes,
channels, AP models, radio types,
and antenna types. If 802.11n is
adopted, the maximum radio
power also depends on the
bandwidth mode.
Optional.
By default, the short preamble is
supported.
Optional.
The default setting for the
command depends on the device
model.
Optional.
By default, the radio can cover 1
km (0.62 miles) at most.
Optional.
By default, the beacon interval is
100 TUs.
Optional.
By default, the DTIM counter is 1.
Optional.
By default, the fragment threshold
is 2346 bytes and must be an even
number.