Displaying And Maintaining Workgroup Bridge; Wlan Access Configuration Examples; Wlan Access Configuration Example - H3C MSR Series Configuration Manual

Step
5. Configure the authentication
method for the workgroup
bridge.
6. Configure the cipher suite
and pre-shared key for the
workgroup bridge.
7. Configure the associated
SSID for the workgroup
bridge.
8. Connect the workgroup
bridge mode to the wireless
network.
9. Disconnect the workgroup
bridge from the wireless
service.

Displaying and maintaining workgroup bridge

Task
Display workgroup bridge
configuration and connection
status.
Display the wireless services
scanned by the workgroup bridge
and the signal quality.

WLAN access configuration examples

WLAN access configuration example

Network requirements
As shown in
provides a plain-text wireless access service with SSID service. 802.11g is adopted.
Figure 7 Network diagram
Configuration procedure
1. Configure the fat AP:
# Create a WLAN BSS interface.
<AP> system-view
Command
client-mode
authentication-method
{ open-system | shared-key |
wpa2-psk }
client-mode cipher-suite { ccmp
| tkip | { wep40 | wep104 |
wep128 } [ key-id key-id ] } key
pass-phrase [ cipher | simple ]
key
client-mode ssid ssid
client-mode connect
client-mode disconnect
Command
display wlan client-mode radio
[ | { begin | exclude | include }
regular-expression ]
display wlan client-mode ssid
[ ssid ] [ | { begin | exclude |
include } regular-expression ]
Figure 7, enable the client to access the internal network resources at any time. The AP
20
Remarks
Optional.
By default, open system
authentication is used.
Optional.
By default, no cipher suite or
encryption key is configured.
By default, no associated SSID is
configured.
Optional.
Optional.
Remarks
Available in any view.
Available in any view.