H3C MSR Series Configuration Manual page 30

# Configure the SSID as China-net.
[AP-WLAN-Radio2/0] client-mode ssid China-net
# Connect the AP to the wireless network.
[AP-WLAN-Radio2/0] client-mode connect
[AP-WLAN-Radio2/0] return
Verifying the configuration
Use the display wlan client-mode radio command to display the configuration and connection
status for the workgroup bridge.
<AP> display wlan client-mode radio
--------------------------------------------------------------------------------
Radio
Mode
Authentication Method : Shared-Key
Cipher Suite
Key (Simple)
WEP Key ID
SSID
BSSID
Status
--------------------------------------------------------------------------------
Received Packets
Data
Management
Sent Packets
Data
Discarded Packets
Rate(Rx/Tx)
Online Duration
--------------------------------------------------------------------------------
The output shows that the AP that operates as a workgroup bridge has been successfully associated
with wireless service China-net.
Configuration guidelines
•
As shown in
workgroup bridge to the AP, and Radio 2 connects the workgroup bridge to the client. To enable
the client associated with Radio 2 to access the AP through the workgroup bridge, you need to
disable wireless user isolation by performing the wlan-client-isolation enable command on
the workgroup bridge.
Figure 10 Workgroup bridge with two radio interfaces
WLAN Client Mode
: 1
: 802.11g
: WEP40
: 12345
: 1
: China-net
: 000f-e233-5501
: Connected
: 1324939
: 34876
: 46365
: 38272
: 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
: 0 days 0 hours 45 minutes 5 seconds
Figure 10, the workgroup bridge has two radio interfaces. Radio 1 connects the
Radio 1
Workgroup Bridge
AP
Radio 2
Client
23