H3C MSR Series Configuration Manual page 74

[Sysname-WLAN-BSS1] quit
# Configure interface Ethernet 1/0 to use the 802.1p priority of received packets for priority
mapping.
[Sysname] interface Ethernet 1/0
[Sysname-Ethernet1/0] qos trust dot1p
[Sysname-Ethernet1/0] quit
# Create a clear-type WLAN service template, configure its SSID as market, configure its
authentication method as Open System, and then enable the WLAN service template.
[Sysname] wlan service-template 1 clear
[Sysname-wlan-st-1] ssid market
[Sysname-wlan-st-1] authentication-method open-system
[Sysname-wlan-st-1] service-template enable
# Configure the radio type as 802.11g for radio interface WLAN-Radio 2/0, and map service
template 1 to interface WLAN-BSS1 on the radio interface.
[Sysname] interface wlan-radio 2/0
[Sysname-WLAN-Radio2/0] radio-type dot11g
[Sysname-WLAN-Radio2/0] service-template 1 interface wlan-bss 1
# Enable WMM on radio interface WLAN-Radio 2/0/.
[Sysname-WLAN-Radio2/0] wmm enable
[Sysname-WLAN-Radio2/0] quit
After WMM is enabled, you can use the display wlan wmm radio command to view
WMM-related information.
CAC service configuration example
1. Network requirements
As shown in
Enable CAC for the AC-VO and AC-VI queues of the fat AP. Use a users-based admission
policy to allow up to 10 users to access, so that enough bandwidth can be guaranteed for the
clients using high-priority queues (AC-VO and AC-VI queues).
Figure 30 Network diagram
2. Configuration procedure
# Configure interface WLAN-BSS 1 to use the 802.11e priority of received packets for priority
mapping.
<Sysname> system-view
[Sysname] interface wlan-bss 1
[Sysname-WLAN-BSS1] qos trust dot11e
[Sysname-WLAN-BSS1] quit
# Configure interface Ethernet 1/0 to use the 802.1p priority of received packets for priority
mapping.
Figure 30, a fat AP is connected to an Ethernet and has WMM enabled.
67