Teldat T200 Installation Manual page 9

Teldat S.A.
Fig. 8: T200 Fast Ethernet Port (FE 0)
SERIAL:
Multistandard serial interface to connect an external modem, POS, or to connect to a WAN (wide area network) such
as X.25, Frame Relay, PPP, etc.
It requires an insertable driver (V.24, V.35, V.36, X.21, RS-485) to operate.
Fig. 9: SERIAL connector
1.2.2.1 Connecting for configuration
The Teldat T200 has a RJ45 female connector on the rear panel labeled CONF. , which provides access to the
router's local console. For configuration purposes, connect the CONF. port to an asynchronous terminal (or
to a PC with terminal emulation).
Fig. 10: T200G Configuration connector (CONF.)
Fig. 11: T200 Configuration connector (CONF.)
The terminal configuration is as follows:
- Speed: 9600 bps
- Eight data bits
- One stop bit
- No parity bit
- No type of flow control
To connect to the configuration port, use the RJ45 connector cable and the RJ45 female-DB9 female adaptor, both
provided with the router. In cases where the terminal has DB25 connections, you must use an additional adapter.
Teldat T200 Router Family
1 Installation
5