Disposal And Recycling - AUMA ABG 10.2 Operation And Maintenance Manual

ABG gearbox:

Remove screw plug (539.0) at the ABG housing.

Fill with new grease.

Clean mounting faces at housing and insert screw plug (539.0) with new sealing S1 (014) and
fasten them to the appropriate torque according to table 1.
After maintenance:

Fasten gearbox to valve again.

Perform test run to ensure proper function.

Check the gearbox for damage to paint finish. Do a thorough touch-up to prevent corrosion.
Original paint in small quantities can be supplied by AUMA.

7. Disposal and recycling

AUMA gearboxes have an extremely long lifetime. However, they have to be replaced at one point in
time. AUMA recommends the following disposal methods:
Our gearboxes have a modular design and may therefore easily be disassembled, separated and sorted
according to materials, i.e.:

Various metals

Plastics

Greases and oils
The following generally applies:

Collect greases and oils during disassembly. As a rule, these substances are hazardous to water
and must not be released into the environment.

Arrange for controlled waste disposal of the disassembled material or for separate recycling
according to materials.

Observe the national regulations for waste disposal.
Page 9 of 12