Bowflex Max Trainer M3 Service Manual page 52

8. Remove the indicated Cap from both sides of the machine.
9. Using a 6mm hex wrench, remove the hardware exposed from below
Leg Assembly
the Cap from both sides of the machine.
Cap
10. Slide the Leg Assemblies off of the machine.
11. Using a #2 Phillips screwdriver, remove the indicated screw from the
Rear Shroud.
12. Carefully remove the Rear Shroud from the machine. Place a standard
screwdriver behind and near the middle of the Rear Shroud and gently pry
until it releases. Then move the screwdriver to the bottom and gently pry
until the Rear Shroud comes off.
Rear Shroud
13. Remove the indicated Caps from the machine.
Cap
Cap
14. Using a #2 Phillips screwdriver, remove the indicated (by ovals)
screws and only loosen the lowest indicated screw (arrow) from the Left
Fan Cover.
15. The Left Fan Cover Assembly has a tab that needs to be pushed
upward to clear the loosened screw. While pushing up on the tab, remove
the Left Fan Cover Assembly.
52