Bowflex Max Trainer M3 Service Manual page 130

20. Using a 6mm hex wrench, remove the hardware that connects the Connec-
tor Arms and the Pivot Arms.
Note: Slowly lower the Connector Arm downward onto the rag or protective
material protecting the Shrouds.
21. Carefully remove the Shrouds from the machine.
If replacing the Right Fan Cover:
A. Using a 15mm open face wrench, remove the Securing Ring from the out-
side of the Right Fan Cover.
B. Remove the AC Inlet from the inside of the Right Fan Cover.
22. Installation is the reverse procedure.
Note: When replacing the Crank Arms, be sure the Right and Left Crank Arms
are oriented inline and opposite each other.
The Crank Nuts should be tightened to a torque value of 29-32.5 ft lbs (or 350-
390 in lbs).
23. Final Inspection
Inspect your machine to ensure that all hardware is tight and components are properly assembled.
Do not use until the machine has been fully assembled and inspected for correct performance in accordance with the Owner's
Manual.
Pivot Arm
Connector Arm
Securing Ring
130
AC Inlet