5. Using a #2 Phillips screwdriver, remove the indicated (by ovals)
screws and only loosen the lowest indicated screw (arrow) from the
Right Fan Cover.
Note: Loosen the lowest screw by at least 3 full rotations.
6. The Right Fan Cover has a tab that needs to be pushed upward to
clear the loosened screw. While pushing up on the tab, remove the
Right Fan Cover from the assembly.
Note: the AC Power Cable is attached to the inside of the Right Fan
Cover. Be sure not to crimp the cable by placing the Right Fan Cover
close to the front of the machine.
Tab
7. Remove the indicated Cap from both sides of the machine.
8. Using a 6mm hex wrench, remove the hardware exposed below
the Cap from both sides of the machine.
Leg Assembly
Cap
9. Slide the Leg Assemblies off of the machine.
127