Bowflex Max Trainer M3 Service Manual page 19

8. The Brake Magnets should be aligned with the Brake Disc and
centered around the Brake Disc.
9. If the Brake Assembly only needs to be slightly adjusted, loosen
the front screw that secures the Brake Assembly using a 10mm hex
wrench. Rotate the Brake Assembly until the Magnets are aligned
and of equal distance from the Brake Disc.
If the Brake Assembly must be fully shifted, loosen the 2 screws (indi-
cated by arrows) that secure the assembly and shift it until centered
and aligned with the Brake Disc. Fully tighten the hardware.
Brake Assembly
Rotate the Brake Disc to be sure it does not make contact with the
magnets. If further adjustment is needed, repeat step 8.
10. Installation is the reverse procedure.
11. Final Inspection
Inspect your machine to ensure that all hardware is tight and compo-
nents are properly assembled.
Do not use until the machine has been fully assembled
and inspected for correct performance in accordance
with the Owner's Manual.
19
Brake Disc
Brake Assembly
Magnets
=