Bowflex Max Trainer M3 Service Manual page 107

3. Carefully lift the Console Assembly and expose the Cable Connections
and disconnect them.
Note: Do not crimp any of the Console Cables.
On the M3 machine be sure not to stretch, crimp, or damage the cable
that runs from the Frame Assembly to the Shifter Assembly.
4. Using a #2 Phillips screwdriver, remove the 4 indicated screws that
secures the Keypad Assembly to the Static Handlebars.
Note: Observe how the cable routes through the Static Handlebar from
the Keypad Assembly to assist with re-assembly.
5. Remove the old Keypad Assembly and replace with the new one, cor-
rectly outing the cable through the Static Handlebars.
6. Re-assemble the machine in the reverse order of when the parts were
removed.
7. Final Inspection
Inspect your machine to ensure that all hardware is tight and components
are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Owner's Manual.
Shifter
Assembly
Cable
107