Bowflex Max Trainer M3 Service Manual page 46

Note: The Bowflex Max Trainer
M3 is used in the following images. The
®
procedure is the same for the M5 model.
1. From the side with the Crank Arm that needs to be replaced, remove
the indicated Cap.
Note: The following photos show the removal of the Left Crank Arm.
Leg Assembly
2. Using a 6mm hex wrench, remove the hardware exposed from below
Foot Pedal
Cap
the Cap.
3. Lift the Foot Pedal and slide the Leg Assembly straight off the ma-
chine. Be sure to pull straight out, or the Leg Assembly may be difficult to
remove.
Note: A rubber mallet may be necessary if the Leg Assembly will not slide
off.
4. Using a 5mm hex wrench, remove the indicated hardware from the
Upper Handlebar.
Note: Be aware that the Upper Handlebar must be supported when
removing the hardware.
5. Using a #2 Phillips screwdriver, remove the 2 indicated screws from the
Crank Cover.
Crank Cover
Note: The image displays the Right Crank Cover being removed.
6. Remove the Crank Cover from the machine.
46