Load Sharing; Brake - Danfoss VLT DriveMotor FCP 106 Operating Instructions Manual

Electrical Installation
Control terminals
BUS TER.
OFF ON
61 68 69 18 19 27 29 42 45 50 53 54
0/4-20mA A OUT / DIG OUT
Illustration 4.10 Control Terminals
Terminal Function Configuration
number
12 +24 V output
18 Digital input *PNP/NPN
19 Digital input *PNP/NPN
20 Com
27 Digital input *PNP/NPN
29 Digital input *PNP/NPN
50 +10 V output
53 Analog input *0-10 V/0-20 mA/
4-20 mA
54 Analog input *0-10 V/0-20 mA/
4-20 mA
55 Com
42 12 bit *0-20 mA/4-20
mA/DO
45 12 bit *0-20 mA/4-20
mA/DO
1, 2, 3 Relay 1 1,2 NO 1,3 NC
4, 5, 6 Relay 2 4,5 NO 4,6 NC
Table 4.3 Control Terminal Functions
* indicates default setting
Note: PNP/NPN is common for terminals 18, 19 and 27

4.8.2 Load Sharing

Load sharing is not permissible.

4.8.3 Brake

The frequency converter has no internal brake. An external
brake can be connected between the UDC+ and UDC-
terminals. Limit the voltage between these terminals to
maximum 768 V.
MG03L202
Operating Instructions
0/4-20mA A OUT / DIG OUT
12 20 55
GND
GND
Factory
setting
Start
No operation
Coast inverse
Jog
Ref1
Ref2
Analog
Analog
[9] Alarm
[5] Drive
running
Danfoss A/S © Rev. 06/2014 All rights reserved.
NOTICE
Increasing voltage beyond the limit will decrease
lifetime, and may permanently damage the frequency
converter.
4 4
21