Table of Contents
Advertisement
2.3. Sauna Time Setup
Through the Sauna Time Setup menu you can make
timer settings for your sauna.
•
The operating time is the time the heater is on.
•
The pre-setting time is the delay period after
which the heater starts heating up the sauna. Do
not forget to activate Heater ON and/or Steamer
ON icon on the screen, depending for which
function you wish to set the pre-setting time.
EN
From the
Main Menu choose
2.4. Heater and Steamer Setup
2.4.1. Heater Setup
Under the Heater Setup menu you can set the
temperature that the heater is expected to create
in the sauna room.
While the AUTO ON icon is activated, the heater
will switch on automatically when you press the
Sauna ON/OFF icon. To switch on the heater with
the AUTO ON icon deactivated, press the Sauna ON
icon and then activate the Heater ON/OFF icon.
To keep your sauna in a good condition for longer,
it is important that you have it dehumidified after
bathing. With Fenix you can do this by leaving the
heater on for a desired period at a temperature of
40
C. Once the function is activated, it will stay on
o
until the setting is changed by the user.
8
2.4.2. Steamer Setup
The steamer is controlled through the Steamer Setup
menu. One of the two modes must be selected:
1) In the %RH Mode (%RH = relative humidity
expressed as a percentage) the humidity sensor
measures the humidity in the sauna room and the
wireless control unit controls the steamer so that
the humidity level is maintained as close to the set
value as possible during the bath.
Set the desired humidity %RH. The sum of the
steamer %RH setpoint and the max. heater setup
cannot exceed 40.
2) The Interval Mode means that the steamer is
on and off periodically. Set the desired duration of
the two periods: for example the ON period at 40
seconds and the subsequent OFF period at 85 s.
Confirm the settings.
While the AUTO ON icon is activated, the steamer
will switch on automatically when you press the
Sauna ON/OFF icon.
Advertisement
Table of Contents
