Starting The Sauna On A Time-Delay Basis (Operation With Preset Time); Deleting The Preset Time - Harvia Sentiotec A2 Instructions For Installation And Use Manual

Instructions for use for the user
9.4. Starting the sauna on a time-delay basis
(operation with preset time)
WARNING!
Risk of fire
Flammable objects that are placed on the sauna heater could ignite and
cause fires.
● NEVER place flammable objects on the sauna heater.
● Make sure that NO flammable objects have been placed on the sauna
heater before you activate the preset timer function.
You can set the preset time in minute intervals. The maximum preset time to-
tals 23 hours and 59 minutes. The preset time is shown in hours and minutes,
e.g. 8 hours and 25 minutes is shown as 08.25.
1. Use the temperature selector 4 to set the preferred sauna temperature.
The further it is turned to the right, the higher the cabin temperature.
2. Press the PLUS time button 3 or hold it pressed down.
► The time is displayed in minutes.
3. Once you have reached the required preset time, release the time button 3.
4. Briefly press the Start/Stop button 5.
► The timer is running, and the remaining preset time appears in the
display 1.
► The dot between the hours and minutes on the display 1 flashes.
► Once the preset time has elapsed, the sauna heater switches on.

9.5. Deleting the preset time

Briefly press the Start/Stop button 5.
► The sauna heater is switched on and begins to heat up.
► The control lights 2 and 8 light up.
► In the display 1, 00.00 is shown continuously.
► With the optional bench sensor: the temperature in the sauna cabin
is displayed.
p. 20/28