Instructions For Installation; Installing The Wireless Control Unit - Harvia Fenix SACF10 Manual

3. INSTRUCTIONS FOR
INSTALLATION
The electrical connections of the control unit may only
be made by an authorised, professional electrician and
in accordance with the current regulations. When the
installation of the control unit is complete, the person
in charge of the installation shall pass on to the user
the instructions for installation and use that come
with the unit and shall give the user the necessary
EN
training to use the heater and the control unit!
For an overall view of the Harvia Fenix control unit
see Figure .

3.1. Installing the Wireless Control Unit

The Fenix wireless control unit comes with a table
recharge stand that can be attached to a table with a
screw. The recharge stand can also be wall mounted
using a separate wall-mounting plate. When installing
the recharge stand, observe the distance to the
nearest socket: the cord measures approximately ,5
m in length. The wall-mounting plate is fixed to the
wall with three screws, and the recharge stand is
fastened to the plate with two screws. The recharge
stand is installed outside the sauna room, in a dry
place with an ambient temperature of >0 ºC. The
wireless control unit can, if necessary, be attached
to the charger with a screw. See Figure 2.
Check the operating range of the radio link (up
to 10 m from the power unit) when installing the
recharge stand. The range varies according to the
structural obstacles.
The wireless control unit can, alternatively, be
connected to the power unit with a cable. The
required operating voltage is then supplied from
the power unit through the cable and batteries can
not be used. If connected to the power unit with
a cable, the wireless control unit can be fixed to
a wall using a special rear cover designed for wall
mounting (see Figure 3). In this case you do not
need a recharge stand.
When you first switch on the wireless control
unit, it will automatically prompt you to calibrate the
touch screen. The screen will guide you through the
calibration process. After this you are asked to choose
the desired panel language and set the day and time.
Make the required settings and confirm. If the unit
does not follow the above steps automatically, they
can be carried out manually (see Quick Guide).
Before the wireless control unit is taken into use,
the installer shall enable the installed features through
the Service Menu.
To add or remove function icons on the screen:
. Go to the Main Menu.
2. Use the page change to scroll through to
Miscellaneous and select.
3. Scroll to Service Menu and enter the service
code 643.
Confirm by pressing
Confirm/Next.
4. Choose Installed/Enabled Features. Here you
can activate the required features, which are
then displayed as function icons on the touch
screen of the wireless control unit.
5. Confirm the settings.
6. Select the desired
function for the auxiliary output and Confirm.
8
Figure 2. Wall mounting of the recharge stand.