Service Mode - SATO CL412E Operator And Technical Reference Manual

Section 3. Configuration
COPY START
YES
MEMORY->CARDCOPY
COMPLETED
CARD COPY/FORMAT
XXXXXXX ERROR
CARD FORMAT
YES
MEMORY FORMAT
YES
CARD MODE

SERVICE MODE

The Service Mode allows the operator to set up the basic operation parameters of the
printer.
ADVANCED MODE
SERVICE MODE
Page 3-18
2. Press the FEED key to accept the selection. If Yes was
selected the copy process will start. If you select No, the
NO
display will return to the previous selection.
3. Once the copy process is completed, press the FEED key
to step the display.
4. If an error is encountered in the copy process, one of the
following messages will be displayed on the second line:
R/W Error
No Card Error
Mem Full Error
Before a PCMCIA card can be used, it must be formatted.
Note: Formatting a card destroys all data currently stored on
NO
the card.
1. Use the LINE key to step the cursor to desired setting. If
Yes is selected, the printer will enter the Card Format
mode. If No is selected, the display will advance to the
mode display.
Before the internal Expanded Memory can be used, it must be
formatted.
NO
Note: Formatting the Memory will destroy any stored data.
1. Use the LINE key to step the cursor to desired setting. If
Yes is selected, the printer will enter the Memory Format
mode. If No is selected, the display will advance to the
mode display.
To exit the Card Mode, power the printer off and then back on.
The Service Mode is entered from the Advanced Mode display
by pressing the LINE key twice.
The Service Mode display indicates that the printer is in the
Card Mode. To advance to the first selection, press the FEED
key.
9001074 Preliminary
Indicates a Read/Write error occured
Indicates no card was recognized
Indicates that there is insufficient
memory available.
SATO CL Series "e" Printers