Section 3. Configuration; Printer Dip Switch Configuration - SATO CL412E Operator And Technical Reference Manual

PRINTER DIP SWITCH CONFIGURATION

DIP Switch Panels
There are two DIP switches (DSW2 and DSW3) located inside the cover. These
switches can be used to set:
Thermal transfer or direct thermal mode
Label sensor enable/disable
Head check mode
Hex dump mode
Single Job or Multi-Job Receive buffer
Operation mode
In addition, a third DIP switch is located on the RS232 Serial Adapter card and is
used to set the RS232C transmit/receive parameters
Each switch is an eight section toggle switch. The ON position is always to the top. To
set the switches, first power the unit Off, then position the DIP switches. Finally, after
placing the switches in the desired positions, power the printer back on. The switch
settings are read by the printer electronics during the power up sequence. They will
not become effective until the power is cycled.
RS232 Transmit/Receive Setting (located on RS232 I/F Mudule)
Data Bit Selection (DSW1-1). This switch sets the printer to receive either 7 or 8
bit data bits for each byte transmitted.
DSW1-1
Off
On
Parity Selection (DSW1-2, DSW1-3). These switches select the type of parity
used for error detection.
DSW1-2
Off
Off
On
On
SATO CL Series "e" Printers
SECTION 3.
CONFIGURATION
SETTING
8 data bits
7 data bits
DSW1-3 SETTING
Off No Parity
On Even
Off Odd
On Not Used
PN 9001074 Preliminary
DSW1
ON
OFF
1 2 3 4 5
DSW1
ON
OFF
1 2 3 4 5
6 7 8
6 7 8
Page 3-1