Setting The Signaling That Indicates When A Button Has Been Pressed - eKey home series Operating Instructions Manual

Setting the
signaling that
indicates when
a button has
been pressed
48│en
4 predefined modes can be used to set the acoustic and optical signaling
that indicates when a button has been pressed. By default, the acoustic
and optical signals indicating that a button has been pressed are on. Enter
the number of the required mode:
□ 0 = acoustic and optical signals off
□ 1 = acoustic signals on and optical signals off
□ 2 = acoustic signals off and optical signals on
□ 3 = acoustic and optical signals on.
The signaling to indicate that a button has been pressed is set via the
Admin menu. Enter the admin code to access the Admin menu.
See "Entering the admin code", page 41.
The system is in the Admin menu.
Step Action
1st
2nd
3rd No action
required.
The optical and acoustic signaling to indicate that a button has been
pressed was set. The system is in normal mode.
Description
Press 5, 4, and the
number of the
required mode. E.g.,
0 for acoustic and
optical signals off.
Press ✓.
Something has been
entered incorrectly.
The signaling was not
changed. Enter the
admin code from the
beginning again.
-
Display
Status LED lights
up green on the
left.
Status LEDs light
up green.
Status LEDs light
up red.
- -
Status LEDs are
off.