Configuration Of Normal Mode And Usage Of The Finger Scanner With Administrator Fingers; Storing Administrator Fingers And Configuring Normal Mode - eKey home series Operating Instructions Manual

Configuration of normal mode and usage
of the finger scanner with administrator
fingers
The devices must have been commissioned before you start your system
administration.
See "Commissioning the system", page 15.
The finger scanner is ready to store the administrator fingers. The
administrator fingers are used for programming the system. However,
they are also able to open doors (like user fingers).
You must store 4 administrator fingers. We recommend storing 2 fingers
of 2 different people for this purpose.
Step Action
1st
2nd
Description
Perform three Finger
Touches on the sensor
within 5 sec. This will
take you to the Admin
menu.
Swipe administrator
finger 1 over the sensor
to store it. Repeat this
step at least twice.
Between each individual
finger swipe, the finger
scanner lights up orange
if the finger storing
process is not complete.
During finger storage
(after the first finger has
been swiped over the
sensor), no more than
10 sec may pass between
each swipe. Otherwise,
the finger storing process
will be aborted.
The quality of the
fingerprint is acceptable.
However, it may be
possible to improve the
quality by swiping the
finger again. If it has not
been possible to obtain a
very good-quality image
after 6 fingerprints (
a good-quality image will
be accepted.
Display
Status LED
lights up
orange,
function LEDs
flash green.
Status LED
lights up
green/All LEDs
/
light up green.
Status LED
and left-hand
function LED
light up green.
Status LED
lights up
red/All LEDs
/
light up red.
Status LED
lights up
green,
function LEDs
light up red.
),
Storing
administrator
fingers and
configuring
normal mode
en│29