Table of Contents
Advertisement
Note: Above instructions are only for input optional module. For VSP 628PRO, if user would
install the output optional module, first, take apart the top panel, and unscrew the 3 fixed screws
on sending card board to remove it (Figure 6).
Then unscrew the 2 fixed screws on output optional module, and pull out the output module
block (Figure 7).
Finally, push the output module into the output module slot, the install steps are the same as
step 4 to step 6 in "Install the Optional Module" part.
Note: There is the case that some customers connect the power cord of the sending card to the
F optional module, shown as Figure 8. This is not allowed to happen, or the F optional module
will be damaged.
VSP 5360
(Figure 5)
(Figure 6)
(Figure 7)
User Manual
Chapter 7: Appendix
76
Advertisement
Table of Contents
