Chapter 2 Installing Your Product; Plugging In Signals; Plugging In Main Power; Turning On Your Product - RGBlink VSP 5360 User Manual

Chapter 2 Installing Your Product

2.1 Plugging in Signals

Connect signals to the product (ensure all devices are powered off first). Tighten connector
screws/locks where provided.

2.2 Plugging in Main Power

Connect IEC cable to device and plug into wall socket. Turn on power at wall socket.

2.3 Turning on Your Product

Turn the power switch on the rear of the product to the ON position.
OLED display will show as below, completing initialization before loading last settings and
input/output configuration.
On delivery, CV1 will be the default input signal at 1920x1080@60, and the output format is
defaulted to 1920×1080@60.
VSP 5360 User Manual
13