Table of Contents
Advertisement
3.18 Saving Views
VSP 5360 provides 12 positions for saving or recording parameters. To save current parameters
and settings:
1. Push the [Save] button, the button light is on, and enable the SAVE function.
2. Some of the buttons 0~12 in PRE area are on, and some flash. The buttons on can be saved,
and flash will be overwrite. Select the location that need to save, for example, button 1, OLED
shows as follows.
3. User can also push the [MENU] button to enter the menu items, and choose <SYSTEM> option,
turn the knob and choose <SAVE TO>, show as follows:
Push the knob to confirm. Turn the knob again, and choose the save mode, for example, save to
4.
mode1, OLED shows as follows:
VSP 5360
PUSH THE LEDS ARE ON TO SAVE
Button is on can be saved
Button flashes will be overwrite
SAVE TO USER CONFIG MODE 1
SAVE IS SUCCESSFUL
->SAVE TO
RECALL
CLEAR
CLEAR ALL
SAVE TO USER CONFIG MODE 1
SAVE IS SUCCESSFUL
Note
If position 1 is saved, this will be recalled and loaded
at power on.
User Manual
Chapter 3 : Using Your Product
>>
>>
SAVE1
>>
43
Advertisement
Table of Contents
