Table of Contents
Advertisement
on program output.
3.4.3 Preset
After setting, the layers on the preview output, we do not need to switching to the program
output. Push the [Save] button, the button light is on, and some of the buttons 0~12 in PRE area
are on, and some flash. The buttons on can be saved, and flash will be overwrite. Select the
location that need to save , for example, button 1, OLED shows as follows.
3.4.4 Load
User can load the saved settings by pushing the [Load] button. For example, push button 1, the
SAVE 1 will display on preview monitor, then touch [TAKE] button to switch it to the program
display after confirmation.
VSP 5360
SAVE TO USER CONFIG MODE 1
SAVE IS SUCCESSFUL
User Manual
Chapter 3: Using Your Product
28
Advertisement
Table of Contents
