Message Types; Processing Messages - Boge base control Operating Instructions Manual

Troubleshooting
Part 6: Troubleshoot-
ing
No. Message Type
1. Warning / mainte-
nance message
2. Fault message
BOGE base control for scroll compressors
6.1

6.1 Message Types

Two types of message may appear:
Meaning
A warning has been issued or servicing
work must be carried out.
The compressor is still operational.
The control is signaling a fault.
The compressor is switched off.
Tab. 6.1: Message Types

6.2 Processing Messages

The following procedure is recommended when an event occurs that causes
one of the message types to appear:
1. Determine / narrow down the cause of the message using the table below,
which contains a list of messages and message codes.
2. If necessary, have the fault rectified by BOGE Service personnel.
CAUTION
Compressor Damage
Arranging to have faults and problems rectified (including maintenance
and repair work) by unauthorized or unqualified personnel may damage or
destroy the compressor.
 Faults and problems may only be rectified by authorized and qualified
personnel or BOGE Service personnel.
 If in doubt, contact BOGE Service.
3. Acknowledge the message (see page 33).
 As soon as the cause has been rectified successfully and the message
acknowledged, the compressor should be operational again without
restrictions.
Message Types
Visualization / Display of the Message Type
The "Fault" indicator lamp is flashing
rapidly. The wrench symbol is
+
flashing on the main display.
Pressing the Info key
the message code.
The "Fault" indicator lamp flashes
and a message code is shown on
the main display.
displays
Page 31