Changing Parameters / Settings; Data Security; Damage To The Control Unit; Operator And Personnel - Boge base control Operating Instructions Manual

Safety
Changing Parameters /
Settings

Data Security

Damage to the Control
Unit

Personnel Requirements

BOGE base control for scroll compressors
2.3
The control regulates the compressor using specific parameters / settings.
The individual parameters represent the values that can be used to change
the compressor functions (e.g. switch-on and switch-off pressure) so that the
compressor generates compressed air as required. However, incorrect set-
tings can also lead to operational faults or destruction of the compressor.
CAUTION
Compressor Damage
Changing parameters / operational settings that have an effect on the oper-
ation or function of the compressor may damage or destroy the compres-
sor.
 Only authorized, qualified personnel may make changes to parameters
or settings.
 If in doubt regarding a change to operational settings, contact BOGE
Service.
The base control automatically stores all data – e.g. altered settings – in the
non-volatile memory. The saved data are therefore also available in the event
of a power failure.
All keys on the control unit are operated by tapping on them with a finger. Light
tapping on the interface is sufficient to actuate the keys. Do not use any sharp
or abrasive objects when operating the control unit. BOGE accepts no liability
for damage resulting from improper use.

2.3 Operator and Personnel

Only individuals who are able to carry out the work correctly and reliably and
who meet the following requirements may perform work on the control:
Trained Personnel
Trained personnel are individuals who have been informed in detail by the
operator of the potential dangers concerning the tasks assigned to them and
for whom this training has been documented.
Qualified Personnel
Qualified personnel are individuals who are able to successfully carry out work
assigned to them, recognize potential dangers independently and avoid injury
to individuals or property due to their professional training, knowledge and
experience as well as their knowledge of the relevant regulations.
Operator and Personnel
Page 7