Processing; Enable Buffered Key Output; Same Buffer Limit; Delay Between (Key) Buffers - Honeywell MX7 Tecton User Manual

Processing

The Processing tab contains a user configurable key delay that applies to scanned bar codes as they are input when Remote
Desktop is the application with the input focus.
Setting

Enable buffered key output

Same buffer limit (characters)
Delay between buffers
Note: Settings on this panel have no effect when RFTerm is the application with the input focus.
Enable buffered key output
Default is enabled (checked). Tap the check box to turn off buffered key output.
Enabled (checked) and dimmed. The user cannot change this setting.

Same buffer limit

Default is 32 ms. Raise or lower this value as desired.

Delay between (key) buffers

Specifies the number of milliseconds to delay after each character in the scanned bar code is processed as a keystroke.
This value may need to be adjusted depending on the network traffic in the environment. The default value is 75 ms. Valid
range is from 0 to 9999. A zero value is No Delay between characters.
178
Default
Enabled
32
75 ms