4.3
SD Memory Cards
This section shows the SD memory cards inserted and used in MES interface module.
Connectable SD memory cards (sold separately)
The following table shows the connectable SD memory cards.
For using SD memory cards, make sure to refer to the following section. (Page 59 Considerations for using SD memory
cards)
Model name
NZ1MEM-2GBSD
NZ1MEM-4GBSD
NZ1MEM-8GBSD
NZ1MEM-16GBSD
Inserting and removing method of SD memory cards
Make sure to stop the file access when removing or replacing the SD memory card.
If the power is OFF and the file access is not stopped, turn the power ON and stop the file access.
Inserting procedure
(1)
Removing procedure
(3)
4 PROCEDURE BEFORE OPERATION
58
4.3 SD Memory Cards
Description
SD memory card 2 GB
SD memory card 4 GB
SD memory card 8 GB
SD memory card 16 GB
1.
Insert an SD memory card (1) straight into the SD memory card slot with
its cutout pointed down.
Make sure it is not uplifted after inserting it.
(2)
If it is inserted insufficiently, it may cause malfunction due to poor contact.
2.
The CARD RDY LED (2) keeps flashing until the SD memory card is
ready to be used. Once the CARD RDY LED (2) turns ON, the SD
memory card can be used.
1.
Press the SD memory card lock switch (1) for one second or longer to
stop the SD memory card access.
2.
The CARD RDY LED (2) is flashing while stopping the file access, and it
(2)
turns OFF once the processing is completed.
3.
Push the SD memory card (3) in once, and pull it out straight.
(1)
Manufacturer
MITSUBISHI