4.3
SD Memory Card
This section shows an SD memory card to insert and use in an MES interface module.
Connectable SD memory cards (sold separately)
The following table shows the connectable SD memory cards.
For using an SD memory card, make sure to refer to the following:(Page 70 Considerations for using an SD memory
card)
Model name
NZ1MEM-2GBSD
NZ1MEM-4GBSD
NZ1MEM-8GBSD
NZ1MEM-16GBSD
Insertion/removal method of an SD memory card
Make sure to stop the file access when removing or replacing the SD memory card.
If the power is OFF and the file access is not stopped, turn the power ON and stop the file access.
Insertion procedure
(1)
Removal procedure
(3)
Description
SD memory card 2 GB
SD memory card 4 GB
SD memory card 8 GB
SD memory card 16 GB
1.
Insert an SD memory card (1) straight into the SD memory card slot with
its cutout pointed down.
Make sure it is not uplifted after inserting it.
(2)
If it is inserted insufficiently, it may cause malfunction due to poor contact.
2.
The CARD RDY LED (2) keeps flashing until the SD memory card is
ready to be used. Once the CARD RDY LED (2) turns ON, the SD
memory card can be used.
1.
Press the SD memory card lock switch (1) for one second or longer to
stop the SD memory card access.
2.
The CARD RDY LED (2) is flashing while stopping the file access, and it
(2)
turns OFF once the processing is completed.
3.
Push the SD memory card (3) in once, and pull it out straight.
(1)
Manufacturer
MITSUBISHI ELECTRIC
4 PROCEDURE BEFORE OPERATION
4.3 SD Memory Card
4
69