Mitsubishi Electric RD81MES96 User Manual page 29

■Access by specifying the network number and the station number of a target station
A target device can be accessed via a relay station when the target device is connected within eight networks from a station,
on which an MES interface module is mounted, and can be identified by the network number and the station number (or CPU
number).
: Accessible, : No combination
Access route
CC-Link IE Controller Network
CC-Link IE Field Network
MELSECNET/H network
*3
Ethernet
*1 It can access to an RnENCPU only in a single CPU system.
*2 No combination with the MELSECNET/H network for process CPUs and safety CPUs.
*3 It is also supported by a QCPU (Q mode) for which the MELSOFT connection extended setting was set.
■Access by specifying the start I/O number of a module to be routed and the station number of
a target station
The following table shows the accessible routes to connect with a target device and a station on which an MES interface
module is mounted directly.
: Accessible, : No combination
Access route
CC-Link
*1 It can access to an RnENCPU only in a single CPU system.
Type of target device (series)
RCPU QCPU (Q mode)
Programm C Programm
able Controller able
controller module controller
CPU/ CPU/
Process Process
CPU/ CPU
Safety
CPU
*1,*2
  
(CPU No.1 to (CPU No.1 to (CPU No.1 to
4) 4) 4)

Type of target device (series)
RCPU QCPU (Q mode)
Programm C Programm
able Controller able
controller module controller
CPU/ CPU/
Process Process
CPU/ CPU
Safety
CPU
*1
  
(CPU No.1 to (CPU No.1 to (CPU No.1 to
4) 4) 4)
2.2 Accessible Devices and Range
LCPU
C Programm
Controller able
module controller
CPU
 
(CPU No.1 to

4)

 
LCPU
C Programm
Controller able
module controller
CPU
 
(CPU No.1 to
4)
2 SPECIFICATIONS
27
2