OPERATION
...........................................................................................................................................................................................................
Programming
For programming the TERZ 94 / 94-S, there are four buttons on the rear side of the board.
Alternatively, you can program the device with the programming module. The programming module
is to be connected to the pin connector indicated in the picture below.
22
P
Programming
module
Programming with the programming module is to be performed in the same way as with the
buttons.
...........................................................................................................................................................................................................
X6_0
CX2
X5
CX3
CX1
X7
RESET
Taster
X151
Programming
keys
→
|
-
+
P
Manual TERZ 94 · EN09a · 2017-11