Technical Manual Switch Actuators AMI/AMS
4.4.2 On/Off delay
The following illustration shows the setting options at the ETS‐Software:
Figure 13: On/Off delay
The on‐delay causes a delayed switch of the channel. At sending an on‐signal to the channel, first the
adjusted on delay time expires and afterwards the channel will be switched on.
The off delay works on the same principle. At sending an off‐signal, first the adjusted off delay time
expires and afterwards the channel will be switched off.
Both functions work as well alone as combined. By adjusting "0 seconds" for a delay the function is
switched off.
The following diagram describes the combination of on and off delay:
MDT technologies GmbH • 51766 Engelskirchen • Papiermühle 1
22
Tel.: +49-2263-880 • Fax: +49-2263-4588 • knx@mdt.de • www.mdt.de