Technical Manual Switch Actuators AMI/AMS
4.6 Current measurement
The current measurement must be activated for every chanel at the accordingly parameter:
Figure 24: Activation current measurement
If the current measurement is activated, a new submenu will appear. At his submenu, the current
measurement can be parameterized for this channel.
4.6.1 General settings
The current measurement can be parameterized for the adjusted channel at the according submenu:
Figure 25: General settings current measurement
The following general settings can be done for the current measurement:
ETS‐text
Object selection for the current
measurement
Add the channel to total
current measurement
Send actual value after changes
value
Cyclic sending
Table 26: General settings current measurement
MDT technologies GmbH • 51766 Engelskirchen • Papiermühle 1
35
Tel.: +49-2263-880 • Fax: +49-2263-4588 • knx@mdt.de • www.mdt.de
Dynamic range
[default value]
Whole value in mA
Floating value in mA
Value in A
Value in kW
not active
active
not active, 1% ‐ 75%
[not active]
not active
15min
30min
60min
90min
120min
comment
Selection of the sending object for the
current measurement
adjusts, whether the channel hall be
addicted to the total current
measurement
Activation and adjustment of the
sending of the current value at
determined changes
Activation and adjustment of the
sending of the current value at
determined times