Technical Manual Switch Actuators AMI/AMS
4.6.3 Total current measurement
The total current measurement can be activated for the whole actuator once at the submenu
"General" (have a look at 4.1 General). For every channel can be set, whether this channel shall be
integrated to this measurement or not. The submenu for the parameterization of the total current
measurement is constructed as follows:
Figure 29: Total current
The following settings can be made for the total current measurement:
ETS‐text
Object selection for the current
measurement
Send actual value after changes
value
Cyclic sending
Monitoring exceedance of load
Table 29: Total current
MDT technologies GmbH • 51766 Engelskirchen • Papiermühle 1
38
Tel.: +49-2263-880 • Fax: +49-2263-4588 • knx@mdt.de • www.mdt.de
Dynamic range
[default value]
Floating value in mA
Value in A
Value in kW
not active, 1% ‐ 75%
[not active]
not active
15min
30min
60min
90min
120min
not active
active
comment
Selection of the sending object for the
current measurement
Activation and adjustment of the
sending of the current value at
determined changes
Activation and adjustment of the
sending of the current value at
determined times
Activation of the observation of the
exceedance of the load, have a look at
4.6.3 Monitoring exceedance/deviation
of load