Technical Manual Switch Actuators AMI/AMS
4.3 Identical parameter
The following parameters, which are described at the headings 4.3.x, are as well available at
channels selected as switch as at channels selected as staircase.
4.3.1 Relay operating mode
The following illustration shows the setting options for this parameter:
Figure 7: Operating mode
The following chart shows the dynamic range for this parameter:
ETS‐text
Mode
Table 10: Operating mode
The following diagram shows the behavior of the relay operating mode normally closed and normally
opened. The input for the channels is a KNX‐telegram, which sends alternating 0‐signals and 1‐signals:
MDT technologies GmbH • 51766 Engelskirchen • Papiermühle 1
15
Tel.: +49-2263-880 • Fax: +49-2263-4588 • knx@mdt.de • www.mdt.de
Dynamic range
[default value]
normally opened
normally closed
comment
Relay operating mode of the
channel