Behavior At Bus Power Up/Down - MDT AMI series Technical Manual

Technical Manual Switch Actuators AMI/AMS
4.3.4 Behavior at bus power up/down
The following illustration shows the setting options at the ETS‐Software:
Figure 10: Behavior at bus power up/down
The following chart shows the dynamic range for this parameter:
ETS‐text
Behavior at bus power up/
Behavior at bus power down
Table 15: Behavior at bus power up/down
Every channel can occupy a certain state as well in case of a bus power breakdown as in case of a bus
power return. The channel can be switched off or on, but also stay in its current state by choosing
the parameter "no change".
To avoid problems in case of a bus power breakdown, you should adjust this parameter very
conscientious. Because there is no controlling possible as long as the bus power is down.
MDT technologies GmbH • 51766 Engelskirchen • Papiermühle 1
18
Tel.: +49-2263-880 • Fax: +49-2263-4588 • knx@mdt.de • www.mdt.de
Dynamic range
[default value]

On

Off

no change
comment
Adjustment, how the channel
shall react in case of a bus
power breakdown/return