Restart (Or, "Reboot"); Warm Restart; Cold Restart - Intermec 5055 User Manual

SECTION 2 Operation
"

Restart (or, "Reboot")

" NOTE:
Make sure that a keyboard is attached to the computer BEFORE at-
tempting to perform a warm restart.
If the system locks up during normal operations, you can
reset it by performing either a "warm" or a "cold" restart.
Use the warm restart when you need to clear the system's
memory to run another program but do not want the com-
puter to perform a self-test. When a warm restart does not
restore operation, perform a cold restart.

Warm Restart

If your operating system is Windows 95 or Windows 98, you
can exit the current application, and then perform a warm
restart in the following manner:
1. Press Ctrl+Alt+Del on the keyboard or displayed key-
2. Load, or reload, the desired software application.
3. Resume normal operation.

Cold Restart

You must interrupt all electrical power to the computer to
perform a cold restart. Perform a proper system shutdown,
then momentarily press the On/Off switch on the bottom of
the computer. If the On/Off switch is inaccessible, do one of
the following:
"
"
2-18 5055 Data Collection PC User's Guide
board simulator (this causes the system to reprocess
the autoexec.bat and config.sys files).
For fixed-mount units, unplug the AC power supply
from the wall outlet for a few seconds. Be sure to plug
it back in.
For vehicle-mount units, interrupt power to the DC--
DC power converter for a few seconds.